Cantilever Rack Guide
Cantilever Rack Guide
Item | Weight (lb) |
16-Foot Column | 232.56 |
12-Foot Column | 179.06 |
Double Sided Base | 175.05 |
Single Sided Base | 105.51 |
Arm – Without C-Tip | 35.64 |
(A) Diagonal Attachment
(B) Bolt Assembly 1 1/8″ × 3/8″
(C) Bolt Assembly 2″ × 5/8″
(D) Wedge Anchor
(E) Bolt Assembly 4 5/8″ × 1/2″
(F) Cotter Pins
(G) Arm Key
(H) Diagonal Brace
(I) Straight Brace
1) Attach towers to the base using (4) x © Bolt assemblies – Wedge goes between base and tower, thick part of wedge towards front of tower.
2) Stand up tower / base combo up. Attach straight bracing (I) to outside holes (J) on tower using (E) bolt assemblies.
For 12’ towers, use 4 straight braces. For 16’ towers, use 6 straight braces.
3) Attach diagonal braces (H) to inside holes (K). To do this, attach diagonal braces (H) to diagonal attachments (A) using (B) bolt assemblies . Then attach diagonal attachments to towers using (E) bolt assemblies. Note: Bracing should overlap and resemble the photo below.
4) To secure bases for the floor, install wedge anchors (D) in the bottom holes of bases.
5) Attach arms to outside holes (J) and (L) on towers using bolt assembly (E) and arm key and cotter pin (F) and (G).
Note: All openings between towers will require straight bracing. Diagonal bracing is not used in every opening between towers. Your sales representative will determine where it is needed.Contact US for more detailed guidance before buying storage racks.